Palfinger-crane-manual-error-codes 〈iOS DELUXE〉

Navigate to the "Error Codes" or "Troubleshooting" chapter. Use the index to find your specific code.

Turn the battery disconnect switch off for 60 seconds. Reboot the crane electronics. Some codes are "soft" errors from voltage spikes. Palfinger-crane-manual-error-codes

| Category | Typical Prefix | Meaning | | :--- | :--- | :--- | | | E-01 to E-10 | Low battery, alternator issues, bad ground. | | Sensor (Length/Angle) | E-20 to E-39 | Potentiometer out of range, broken wire in boom tip. | | Pressure/Load | E-40 to E-59 | Overload warning, pressure sensor failure, LMI calibration off. | | CAN Bus / Communication | E-70 to E-99 | Display not talking to central module, wiring harness damage. | Navigate to the "Error Codes" or "Troubleshooting" chapter

Check the sticker on the back of the remote control or inside the pedestal. Many operators miss this simple lookup. Reboot the crane electronics

After a two-hour service call, the technician pressed three buttons on the console—clearing a phantom pressure offset. The bill was $450.