Tsum1pfr-lf Datasheet May 2026

| Parameter | Symbol | Min | Max | Unit | |-----------|--------|-----|-----|------| | Input Voltage | VIN | -0.3 | 6.0 | V | | Enable Voltage | VEN | -0.3 | VIN + 0.3 | V | | Output Voltage | VOUT | -0.3 | VIN + 0.3 | V | | Output Short-Circuit Duration | - | Indefinite | - | - | | Maximum Junction Temperature | Tj | -40 | +150 | °C | | Storage Temperature | Tstg | -65 | +150 | °C | | Soldering Temperature (10 sec) | - | - | 260 | °C | (Test conditions: VIN = VOUT(nom) + 1V, IOUT = 10mA, Tj = 25°C, unless noted. Typical values for an adjustable 3.3V output variant.)

Set R2 = 100kΩ, then R1 = 212.5kΩ (use 215kΩ 1% resistor). 6. Thermal Considerations and PCB Layout Because the Tsum1pfr-lf can deliver up to 1A, thermal management is critical. Power dissipation is calculated as: Tsum1pfr-lf Datasheet

A: Not necessarily. Measure input and output voltage difference. If >1.5V and load is 500mA, heat is normal. Add a heatsink or reduce VIN. If temperature exceeds 125°C at the case, consider a switching regulator. 9. Conclusion The Tsum1pfr-lf datasheet , while not a mass-market published document, describes a component that fits the profile of a modern, lead-free, 1A low-dropout linear regulator. Its key strengths are low quiescent current, tight output accuracy, and integrated protection. When working with this part, prioritize thermal management, verify the actual pinout via continuity tests, and cross-reference with LDOs from Texas Instruments, Diodes Inc., or Richtek if a genuine datasheet remains elusive. | Parameter | Symbol | Min | Max

Formula: Where VREF is typically 0.8V or 1.25V (check your specific datasheet). If >1

A: Lead-free. The device meets RoHS standards. Peak reflow temperature should not exceed 260°C. No special handling required, but soldering must use lead-free alloy.